VXE reclosures

Printable View

10-06-2015, 09:50 AM
Robospace

VXE reclosures

Cooper VXE 400
We have been experiencing the vxe's only operating one time before opening. Has anyone else had this problem and if so, what actions were taken?
10-06-2015, 08:10 PM
rcdallas_

Quote:

Originally Posted by Robospace

Cooper VXE 400
We have been experiencing the vxe's only operating one time before opening. Has anyone else had this problem and if so, what actions were taken?

I am not familiar with a cooper, looks like some single phase deal you might see on a small coop system where they like to mount the control up top the pole.

Dumb question but you sure the dip switches are set correctly? Says something about replaceable TCC cards, sounds like a board you put in there for your curve settings. Maybe if anything lightning fried the board.
10-12-2015, 11:18 AM
Robospace

Curve is correct

Quote:

Originally Posted by rcdallas_

I am not familiar with a cooper, looks like some single phase deal you might see on a small coop system where they like to mount the control up top the pole.

Dumb question but you sure the dip switches are set correctly? Says something about replaceable TCC cards, sounds like a board you put in there for your curve settings. Maybe if anything lightning fried the board.

Changed batteries
checked all curves

This is happening at several locations. They are single phase reclosures, but are used on several three phase lines (3 on the pole) Someone has to have some experience with these reclosers. Thanks for the help.